forums.ps2dev.org

I've been trying unsuccessfully to run the ee-echo sample using ps2client...

I'm getting this error

loadelf: fname ee-echo.elf secname all
Cannot openfile

any ideas of what's wrong? Am I supposed to copy the file to the PS2 before executing it?

Not sure if this is what you're doing (am unable to fire up my ps2 to check error codes at the moment) but are you using 'host' on the ps2client commandline?

ps2client execee host:myelf.elf
is what works.. obviously add the ip address for your particular setup..

doh...
where is that in the docs!..

no.. I wasn't using host..

now it works!!! thanks a lot!!!!!